Explanation/Annotation:Stationary. For controlling of vibration equipment parameters, determinations current of technical condition, recommendation for following use.
Detailed model description:System is intended for continuous state monitoring of rotating equipment ( the vibration, the temperature etc.. , revealings incipient defects, signalling on availability of strong, issuance of recommendations for scopes and timings of repair operations, forecasting of non-failure operating time, and as a consequence:
- accident prevention of equipment,
- optimization of maintenance planning,
- determination of equipment state in case of its implication of repair.
- reduction of unscheduled downtimes, sparked by accidents in interrepair period.
the used probes are established per nodes equipment subject to inspection and are connected by cable lines with signal processors (barefoots). In barefoots, having the single-board computer (the real-time operating system of QNX) are established also the hardware means for digital signal processing and commutation, the software for condition monitoring, periodicity determination of polling for each measurement point, detailed diagnostics of technical state. Periodicity and the measurements sequence are specified tacitly on the basis of diagnosing results, however the operator at any instant may change the sequence and the measurements priority.
the information from barefoot on ethernet network comes on a personal computer (in case of The need for industrial execution), which serves to reflection and storage of information, the record generations, the performing tasks of operator, the condition diagnostics of measurement paths of system.
peculiarity:
- the deep detailed diagnostics controlled assemblies, allowing reveal even incipient defects,
- the measurement of total level of signal and temporary signal of any sample.
- the possibility Distant Directorate and check of parameter (including via Internet),
- of works with any types of parametric sensors,
- granting of information about current of equipment state all concerned the services and specialists directly on their workplaces. |
